Bosch I 8 OptiMUM Series, Инструкция по применению

Страница: 22 / 140

en Timer
22
7.
To exit the configuration menu, se-
lect one of the following options:
‒
Press and hold , or ⁠.
‒
Start processing.
9 Timer
You can read off the processing time
elapsed or preset a time.
Tip:
You can also monitor times with
the timer, e.g. resting times for
dough.
9.1 Display values of timer
Observe the following values when
using the timer.
Display range 0 seconds to 3
hours
Display steps 1 second
Settings range 5 seconds to 3
hours
Settings steps 5 seconds
9.2 About the timer
To ensure optimum use of the timer,
note the following.
Notes
¡
If the timer is stopped or switched
off during processing, processing
will continue.
¡
When processing is started with
the timer running, the appliance
will end processing on expiry of
the remaining time.
¡
If you interrupt processing for less
than 3 minutes, the last values dis-
played are saved and will resume
if processing starts again.
Tips
¡
You can adjust the remaining time
using or at any time.
¡
Values will change faster if or
is pressed and held down.
¡
You can change the volume of the
signal tones at any time.
→ "Overview of basic settings",
Page 21
9.3 Reading off and resetting
the processing time
Note
Display of the previous processing
time will not start
¡
if the processing time has been
preset.
¡
if the SensorControl Plus function
is used.
1.
Set the rotary switch to the re-
quired speed.
a
The display shows "TIME" and the
previous processing time.
2.
To reset the display to "00:00",
press and hold ⁠.
9.4 Processing ingredients
with the timer
Requirement: The appliance is pre-
pared and the ingredients have been
added.
→ "Processing ingredients with tools",
Page 20
1.
If the display is switched off, press
any button.
2.
Press ⁠.
a
The display shows "TIMER" and
"00:00".
3.
Use or to set the required
duration.
4.
Set the rotary switch to the re-
quired speed.
a
The display shows the remaining
processing time.
a
Once this time has elapsed, a sig-
nal tone sounds and the display
shows "END" "TIMER".