6
T o p r e v e n t d a m a g e t o
the HEPA filter, do not
use this dust extraction attachment when
drilling with liquids or into wet materials.
Never use the dust extraction attachment
without a filter.
If the dust extraction
attachment is used without a filter, larger
p a r t i c l e s o f d r i l l i n g d u s t c a n b e f l u n g
towards the user and the power tool can be
damaged.
Only use an undamaged filter (no cracks,
small holes, etc.). Replace a damaged filter
immediately.
Never carry the power tool by the dust
extraction attachment.
Note:
The guide
5
is spring-loaded. The guide
can spring forward when the button
6
for
drill bit length adjustment is pressed (Fig. 1).
Inserting/Removing
Drill Bits (Fig. 3)
-
Press and hold the button
6
and pull the
guide
5
all the way outward.
-
Release the button
6
.
-
Slide the tip of the drill bit through the
dust cap
3
from behind and then fit the
b i t i n t o t h e c h u c k a c c o r d i n g t o t h e
instructions of your power tool.
-
Before removing the drill bit, press the
button
6
again and pull the guide
5
all
the way outward.
Adjusting the Guide
Length (Fig. 4 & 5)
To ensure that dust is extracted cleanly and
the depth stop is set correctly, the guide
5
must be adjusted so that the tip of the drill
bit is flush at the front with the dust cap
2
or 3
(Fig. 5).
-
Press and hold the button
6
and move
the guide
5
until the tip of the drill bit is
flush with the “crosshair” of the dust
cap
1
.
-
Release the button
6
.
N o t e :
T o s t o r e t h e d u s t e x t r a c t i o n
attachment, press the button
6
and pull the
guide
5
all the way outward. This relieves
s t r a i n o n t h e g u i d e ’ s s p r i n g , w h i c h
increases the lifetime of the spring.
1
2
(5)
(6)
(3)
FIG. 3
(2)(3)
(2)(3)
(2)(3)
1
2
(6)
FIG. 4
Operating instructions
FIG. 5
2610067290 06-21 GDE28D.qxp_GDE18V-16 6/25/21 9:36 AM Page 6
