32
| English
1 609 92A 0XG | (14.8.14)
Bosch Power Tools
Aligning the Scale for Mitre Angles
– Bring the power tool into the working position.
– Turn the saw table
15
to the 0° detent
24
. The lever
21
must be felt to engage in the detent.
Checking:
(see figure V1)
– Adjust an angle gauge to 90° and position it between the
fence
14
and the saw blade
12
on the saw table
15
.
The leg of the angle gauge must be flush with the saw blade
12
over the complete length.
Adjusting:
(see figure V2)
– Loosen all four set screws
56
with a cross-head screw-
driver and turn the saw table
15
together with the scale
17
until the leg of the angle gauge is flush with the saw blade
over the complete length.
– Retighten the screws again.
When the angle indicator
23
is not in line with the 0° mark of
scale
17
after adjusting, loosen screw
57
with a cross-head
screwdriver and align the angle indicator alongside the
0° mark.
Transport (see figure W)
Before transporting the power tool, the following steps must
be carried out:
– Loosen the locking screw
33
if tightened. Pull the tool arm
completely to the front and tighten the locking screw
again.
– Make sure that the depth stop
32
is pushed completely in-
ward and that adjusting screw
4
fits through the recess
without touching the depth stop when moving the tool
arm.
– Bring the machine into the transport position.
– Remove all accessories that cannot be mounted firmly to
the power tool.
If possible, place unused saw blades in an enclosed con-
tainer for transport.
– Wind up the mains cable and tie it together with Velcro
strap
58
.
– Carry the machine by the transport handle
3
or hold it by
the recessed handles
26
on the sides of the saw table.
The power tool should always be carried by two per-
sons in order to avoid back injuries.
When transporting the power tool, use only the trans-
port devices and never use the protective devices.
Maintenance and Service
Maintenance and Cleaning
Before any work on the machine itself, pull the mains
plug.
If the replacement of the supply cord is necessary, this has to
be done by Bosch or an authorized Bosch service agent in or-
der to avoid a safety hazard.
Cleaning
For safe and proper working, always keep the power tool and
its ventilation slots clean.
The retracting blade guard must always be able to move freely
and retract automatically. Therefore, always keep the area
around the retracting blade guard clean.
Remove dust and chips after each working procedure by
blowing out with compressed air or with a brush.
Clean the roller
6
regularly.
To clean the laser unit, turn the laser lens cover
59
outward
and remove any dust using a brush (see figure X).
Accessories
Article number
Material clamp
1 609 B04 224
Insert plates
1 609 B03 717
Dust bag
1 609 B00 840
Material stop
Lock screw of the material stop
1 609 B02 365
1 609 B00 263
Saw blades for wood and plate materials,
panels and strips/mouldings
Saw blade 216 x 30 mm, 48 teeth
2 608 640 641
Saw blades for plastic and non-ferrous metals
Saw blade 216 x 30 mm, 80 teeth
2 608 640 447
Saw blades for all types of laminate flooring
Saw blade 216 x 30 mm, 60 teeth
2 608 642 133
OBJ_BUCH-1736-003.book Page 32 Thursday, August 14, 2014 1:13 PM
