Bosch FLEXIDOME multi 7000i, Руководство по установке

Страница: 24 / 44

24 en | Installation FLEXIDOME multi 7000i
2021-03 | 01 |
Installation manual
Bosch Security Systems B.V.
2. To set each of the four lenses at 0° tilting, which means that the lens captures an image
at 90° to the mounted surface, make sure that the white dot in the middle of the larger
lens holder meets the edge of the smaller lens holder.
3. Do not tilt each of the four any further than until the two white dots on the edges of the
lens holders meet. If you tilt any further, you might see a partly blurry image. Use this
position only in specific use cases or when you need the lens to fully zoom in.
4. To obtain 360° overlapping images, make sure to have a tilt angle from the ceiling of at
least 20° up to 62°:
–
20°: bottom half of the images shows overlap
– 62°: full 360° overview with side by side overlap and without blind spots
5.3.3 Rotating each of the four lenses
1. Rotate each of the four lenses on the camera base to set the position that you need. You
can rotate -20º to 20º.
i
Notice!
Mechanically, each of the four lenses rotates -45º to 45º, but doing so will prevent you from
closing the camera dome cover. Do not rotate more than -20º to 20º.
-20º ~ 20°
x2