Bosch FLEXIDOME multi 7000i, Руководство по установке

Страница: 13 / 44

FLEXIDOME multi 7000i Installation | en 13
Bosch Security Systems B.V.
Installation manual
2021-03 | 01 |
i
Notice!
The plugs and screws for surface mounting are not supplied with the camera.
5.1.1 Installing the mounting plate without conduit
1. Remove the mounting plate from the box.
2. Position the mounting plate with the center hole on top of the cable exit on the surface,
and mark the positions of the screw holes on the surface.
For standard installation, use the mounting holes marked with a B on the mounting plate.
For a different installation, for example for an installation on an electrical box, use
different mounting holes. For more information, refer to
Installing the mounting plate,
page 12.
3. Drill the 4 holes with the appropriate diameter drill to support your 5-6 mm (0.2 in.)
screws and plugs.
4. Install 4 plugs in the holes.
5. Put the cable through the center hole of the mounting plate.
6. Attach the mounting plate to the surface with 4 screws. Tighten the screws between 4
and 7 Nm (3 and 5.2 lbfft).
5.1.2 Installing the mounting plate with conduit (NDA-7051-CA)
For installation with conduit, use the NDA-7051-CA Conduit adapter M25 (sold separately).
NDA-7051-CA contains 5 conduit adapters. Use one conduit adapter per camera.
1.
Remove one conduit adapter from the box.
2. Mark the position of the hole on the surface.
3. Drill the hole with the appropriate diameter drill.
4. Install a plug in the hole.
5. Put the cable through the hole of the conduit plate.