DINION imager 9000 HD
Installation | en
25
then release the bottom hinge pin from the hinge pin stop
to lock the camera arm to the junction box.
5. Put the input/output terminal block on the bracket and
tighten the two slotted screws.
6. Put the power terminal block on the bracket and tighten
the two slotted screws.
7. Reattach the network cable from the camera to the
connector in the junction box.
8. Reattach the BNC connector from the camera to the
bracket in the junction box.
CAUTION!
–
The ITE is to be connected only to PoE networks without
routing to the outside plant.
–
The camera can accept power from the 12 VDC / 24 VAC
power input or from the Ethernet input. Ensure that the
camera receives power from only one source.
9. Attach an Ethernet cable (Cat-5e or Cat-6; maximum
distance 100 m (328 ft) to the connector in the junction
box.
Bosch Security Systems
Installation manual
AM18-Q0663 | 1.0 | 2013.09
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
