18
en | Installation
DINION imager 9000 HD
3.2.1
Changing the angle of IR LED tilt
NOTICE!
Do not discard the additional LED tilt set screw supplied. It
may be required to adjust the angle of LED tilt.
1. Unscrew the current tilt screw located between the
camera window and the IR LED window at the front of the
camera.
Figure 3.1
Slot for set screw for adjusting angle of LED tilt
2. Screw the selected screw as far as possible into the hole.
The screw must be tightened completely to obtain the
desired angle.
WARNING!
The LED Tilt Set screw must be inserted completely so that
the integrated O-ring makes a seal with the camera housing. If
the screw is not completely inserted, the water tightness of
the camera will be compromised.
AM18-Q0663 | 1.0 | 2013.09
Installation manual
Bosch Security Systems
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
