Bosch DECT6000, Руководство по установке

Страница: 26 / 48

7.3.2 Wiring
Connecting the base station
After mounting the base station on the wall, each base station must be connected to a
DCU through the unshielded twisted pair cable.
Proceed as follows (see fig. 7.6):
1. Connect a RJ11 plug to the cable at the base station end. Use the two inner
connectors [a] and [b] of the plug.
2. Insert the plug into the line connector of the base station.
Connection base station-DCU
The connection of the base stations to the BS 0-7 or BS 8-15 connector of the DCU
(see figure 7.7) can be done in two different ways. One way is to solder the 25 pole male
sub D connector to the base station cables (see
1. ), the other way is buying a BS-DCU
connection cable LBB 6721/02 (see 2. ).
1. Soldering the wires to a 25-pole male sub D connector according the pin
configuration in Table 7.1 and plug the connector on the BS connector of the DCU
(see figure 7.7).
CHAPTER 7
Installation Instructions
22 DECT6000
9922
141
80271
03-07
en
Pin Signal BS Pin Signal BS
1 a
0/8
5 a
4/12
14 b 18 b
2 a
1/9
6 a
5/13
15 b 19 b
3 a
2/10
7 a
6/14
16 b 20 b
4 a
3/11
8 a
7/15
17 b 21 b
9…13 Not connected
22…25 Not connected
Table 7.1 Pin configuration of the BS 0-7 and BS 8-15 connector
not connected
not used
b
a
not connected
not used
Figure 7.6 RJ11 Base station connector