Bosch DECT6000, Руководство по установке

Страница: 31 / 48

8.3.2 Connecting base station-extension card
The connection of the base stations to the BS 8-15 connector of the extension card
(see figure 8.3) can be done in two different ways. One way is to solder the 25 pole male
sub D connector to the base station cables (see
1. ), the other way is buying a BS-DCU
connection cable LBB 6721/02 (see 2. ).
1. Soldering the wires to a 25-pole male sub D connector according the pin
configuration in Table 8.1 and plug the connector on the BS 8-15 connector of the
extension card (see figure 8.3).
2. Connect the optional BS-DCU connection cable to the BS 8-15 connector of the
extension card (see figure 8.3) and the wires via a terminal strip, located near by a
PABX, to the base stations (see figure 8.5). For wiring of the BS-DCU connection
cable LBB 6721/02 see Table 8.2.
CHAPTER 8
Installation Instructions
DECT6000
27
9922
141
80271
03-07
en
Pin Signal Line Pin Signal Line
1 a
8
5 a
12
14 b 18 b
2 a
9
6 a
13
15 b 19 b
3 a
10
7 a
14
16 b 20 b
4 a
11
8 a
15
17 b 21 b
9…13 Not connected
22…25 Not connected
Table 8.1 Base station to DCU connector
Pin Signal Wire colour Line Pin Signal Wire colour Line
1 a white/blue
8
5 a white/grey
12
14 b blue/white 18 b grey/white
2 a white/orange
9
6 a red/blue
13
15 b orange/white 19 b blue/red
3 a white/green
10
7 a red/orange
14
16 b green/white 20 b orange/red
4 a white/brown
11
8 a red/green
15
17 b brown/white 21 b green/red
9...13 Not connected
22...25 Not connected
Table 8.2 Connections of the BS-DCU connection cable LBB 6721/02