Bosch DCN-SWSACC, Руководство пользователя программного обеспечения

Страница: 6 / 28

6 en | Installation
Bosch DCN Standalone Automatic Camera
Control
DCN-SWSACC_V4.0 | V1.0 | 2011.10 Software Manual Bosch Security Systems B.V.
2 Installation
This chapter describes how to setup the DCN system and the Camera system. Two different
types of DCN systems are available: single CCU systems and multi CCU systems. Also the
Camera system exists in two different versions: Allegiant video switcher with multiple
cameras and AutoDome which is a single camera.
The system needs to be configured before it can be used operational. To do so, first the
choice has to be made which Camera system is used:
– Section 2.1 Allegiant video switcher , or
– Section 2.2 AutoDome .
– Section 2.3 Cables
– Section 2.4 Software Installation
2.1 Allegiant video switcher
2.1.1 Configuration
1. Set the PC Communication Settings :
– Allegiant : set the baud-rate of the Allegiant to 19k2. Please refer to the Allegiant
user manual how to set the Allegiant’s baud-rate.
– DCN-CCU2 : set the protocol for the serial port via menu 8H to allegiant.
– DCN-CCU (S500): set the protocol for serial port which is connected to the
temporarily PC to camera control and set the baud-rate to 19k2
–
– DCN-NCO : set the baud-rate for camera control to 19k2 using menu item 7l.
2. Make the connections to the temporarily PC according the image below:
–
– Refer to Section 2.3 Cables for cable type (1,6* and 2).
3. Start the DCN-SWSACC software.
– Configure the camera control as described in: Section 3 The DCN-SWSACC
application , Section 4 System , Section 5 Cameras and Section 6 Assign & store .
4. Disconnect the temporarily PC from the DCN system: and the Allegiant .