D621 Series
|
User's Guide | Add A Passcode (Cmd 56)
Bosch Security Systems | 8/04 |
34
5.
Enter the user number you want to add followed by the
[*] key. (For example, to add User 4, press [4] [*].)
6.
Enter the area(s) you want to assign to the new user by
pressing the appropriate numeric key(s). For example, if
the new user is to be assigned to Areas 1 and 2, press the
[1] and [2] keys. To remove a currently assigned area(s),
press the corresponding numeric key(s). The appropriate
point indicator turns off. (For example, if User 4 is
assigned to Areas 1 and 2, but should only be assigned to
Area 1, press [2] to remove Area 2 from User 4’s area
assignment.)
7.
Press [Cmd] twice. Point indicators 1 to 3 flash.
8.
Press [1] to assign a new passcode.
9.
Enter the user number followed by the [*] key. (For
example, press [4] [*] to create the passcode for User 4.)
10.
Enter a new passcode. If the error tone sounds, try a
different new passcode.
11.
Enter the new passcode again for verification. Press [Cmd]
twice. Point indicators 1 to 3 flash.
12.
Press [2] to assign a passcode authority level to the new
user.
13.
Enter the user number followed by the [*] key. (For
example, press [4] [*] to assign an authority level for User
4.)
14.
Enter the authority level.
15.
Press the [Cmd] key until the keypad emits a single beep
tone, the Cmd indicator turns off and the Status indicator
turns on. This indicates that the keypad has exited this
command.
The new user passcode, area assignment, and
authority level are automatically logged into the
system’s programming memory. Make sure your
security company’s programming records are
properly updated.
