Bosch CTL636E SERIES, Инструкция по эксплуатации

Страница: 42 / 136

38
en Initial use
C
start/stop
Press
C
for either beverage preparation
or to launch a service programme
Press
C
again while the drink is being
prepared to prematurely halt dispensing
There are four menu fields in the control
panel which can be activated by touching
The active menu field lights up red.
m
m
lights up as soon as the
appliance is in operation Drinks can be
selected and dispensed or settings for the
drinks can be changed
B
MyCoffee
Touch
B
to open the selection of
“ Personalised beverage preparation”
Personal settings for coffee drinks can
be saved and called up (see the section
“ Personalised drinks”)
A
Menu
Touch
A
to call up the menu Settings
can be made, information called up or the
appliance connected with “Home Connect”
(see section “Menu”)
E
Service
Touch
E
to open the selection of service
programmes. Run the desired programme
as described in the section “Service
programmes”
F
Press
A
,
E
or
B
again to exit
the respective menu
Control ring
Turn the control ring to navigate in the
display or to change parameters
Information display
The round display shows the drink selected,
the settings or information
Touch display (left and right)
Depending on the setting, different fields
are shon in both the touch displays. A field
is activated when touched either to enter
settings or change values
Initial use
General
Fill the appropriate container using only
pure, cold , uncarbonated water and solely
roasted
beans Do not use coffee beans
that have been glazed, caramelised or
treated with other additives containing
sugar, since they will block the brewing unit
A
Before the appliance can be switched
on and used, it must be assembled
and connected according to the
enclosed assembly instructions
Setting up the appliance
■ Remove any protective plastic film.
F
Important:
Only use the appliance
in a frost-free room If it has been
transported or stored at tempera-
tures below 0°C, wait at least 3 hours
before initial use
■ Take hold of the appliance door by the
recessed grip and open
■ Remove the water tank, rinse it and fill it
with fresh water up to the “max” mark
■ Replace the water tank and click into
place
■ Remove the bean container, fill with
coffee beans and replace
■ Set the mains switch to
I
and close
the appliance door
The appliance heats up and is rinsed
The control panel is activated
“Language”
appears
■ Turn the control ring with your finger to
select the desired language and touch the
[ Water hardness ]
field.