Bosch BULLS 650-185, Руководство по эксплуатации

Страница: 62 / 238

61
Assembly
5 Assembly

Assemble the
ebike
in a clean, dry
environment.

The work environment temperature should be
between
60º-75ºF
.

The fitting stand used must be approved for a
maximum weight of least
65lb
.
5.1 Unpacking
The packaging material consists mainly of
cardboard and plastic film.
 Dispose of the packaging in accordance with
the regulatory requirements (see Section 10).

e B ikes
are fully assembled in the factory for
test purposes and then dismantled for
transportation. The
ebike
is 95% to 98% pre-
assembled.
Scope of delivery
5.2 Required tools
The following tools are required to assemble
the
ebike
:
Risk of eye injury
Problems may arise if components are set
incorrectly. They may cause serious injuries to
the face.
 Always wear safety glasses to protect eyes
when assembling
ebikes
.
Crash and crushing hazard caused by
unintentional activation
There is a risk of injury if the drive system is
activated unintentionally.

Remove the battery.
WARNING
!
CAUTION
!
 1 pre-assembled
ebike

1 front wheel
 2 pedals

2 quick releases (optional)
 1 charger

1 set of operating instructions on CD.
 1 battery (supplied separately from the
ebike
)
Knife
Ring spanners
8 mm, 9 mm, 10 mm, 13 mm, 14 mm and 15 mm
Torque wrench
Working range 5–40 Nm
by.Schulz handlebars:
TORX® bits: 4 mm, 5 mm and 6 mm
If not:
Hexagon bits: 4 mm, 5 mm and 6 mm
Hexagon socket spanner
2 mm, 2.5 mm, 3 mm, 4 mm, 5 mm, 6 mm and
8 mm
Spline nut socket
T25
Cross-recess screwdriver
Slotted-head screwdriver
Table 28: Tools required for assembly