Bosch BULLS 650-185, Руководство по эксплуатации

Страница: 186 / 238

185
Maintenance
installing the outer sleeve and slide bushing
1 Carefully push slide bushing tube into the seat
tube.
2 Press outer sleeve downwards with your hand.
3 Use a 3 mm hex spanner to fasten the
attachment screw on the outer sleeve.
Figure 206: Fitting the slide bushing and outer sleeve
Fitting the seat post
1 Attach cable head to the hydraulic
activation lever bracket.
2 Push special end cap for the outer sleeve into
the holder on the mounting interface.
3 Carefully push the seat post into the frame. In
doing so, ensure that the wiper and the slide
bushing do not become damaged.
Figure 207: Attaching and pushing in the seat post
4 Hold the cable firmly on the
handlebars while feeding it in. Carefully pull
the end of the cable from the frame so that the
seat post slides downwards unhindered.
Figure 208: Attaching the end cap
5 Look at the frame interface through the hole in
the Postpin. Push the seat post down until the
Postpin mounting interface on the seat post
reaches the Postpin interface on the frame.
Figure 209: Hole in the Postpin interface
6 If necessary, turn the seat post slightly and
push it to the correct position so that the
Postpin axle can be inserted.
7 Use a 5 mm hex spanner to screw in Postpin
axle and fasten slightly.
8 Straighten saddle.
9 Use torque spanner to tighten Postpin axle with
8 Nm.
Figure 210: Screwing the seat post into position