Bosch BULLS 650-185, Руководство по эксплуатации

Страница: 181 / 238

180
Maintenance
installing the outer sleeve and slide bushing
1 Carefully push slide bushing tube into the seat
tube.
2 Press outer sleeve downwards with your hand.
3 Use a 3 mm hex spanner to fasten the
attachment screw on the outer sleeve.
Figure 173: Fitting the slide bushing and outer sleeve
Fitting the seat post
1 Attach the outer sleeve end cap in the
counterholder on the seat post frame interface.
Figure 174: Attaching the end cap
2 Use both thumbs to push white activation slider
downwards and hold with one thumb.
Figure 175: Pushing the white activation slider
downwards
3 Attach cable with the nipple to the
bracket for the cable.
Figure 176: Correct and incorrect cable
4 Carefully push cartridge into the seat tube.
Pull the cable out of the frame to help.
Figure 177: Fastening the cartridge valve lid
5 Look at the frame interface through the hole in
the Postpin. Push the cartridge down until the
Postpin mounting interface on the seat post
reaches the Postpin interface on the frame.
6 If necessary, turn the seat post slightly and
push it to the correct position so that the
Postpin axle can be inserted.
Figure 178: Fastening the cartridge valve lid
7 Use a 5 mm hex spanner to screw in Postpin
axle and fasten slightly.
8
T
ighten Postpin axle
to 8 Nm
Figure 179: Fastening the Postpin axle
Notice
 Never pull cable forwards at an angle.
Notice
 Before continuing with installation, ensure that
the cable is fed into the middle of the
longitudinal guide. If the cable is off cent
e
r, it
will be pinched by the tube.