On this Display
Operation
Description
Operating Instructions
15
• When a high temperature is set, the readout on the right is shown.
• Please check the temperature displayed before using any hot water.
Be especially careful using any hot water after any
previous setting of between 60 - 80
°
C.
• If the power switch on the remote controller is turned “on”, the
remote controller has priority in adjusting the temperature.
• When the temperature can be adjusted (console has priority), the
display screen is shown as per right.
• If the temperature cannot be adjusted, turn the power switch “off”,
and then turn it “on” again.
Approximate hot water conditions
Washing
dishes, etc.
Shower, hot water supply, etc.
Hot water supply, etc.
High temperature
37 38 39 40 41 42 43 44 45 46 47 48 50 55 60 65 70 75 80
Set the maximum temperature to suit your own preference. (
P18 and 19)
• Hot water temperatures are approximations, and may differ from actual temperatures depending
on external factors, such as the season and length of piping involved.
• When low temperatures are set (for washing dishes, etc.), if the ambient water temperature is already
quite high, it may be difficult to ensure the resultant water temperature is as per the setting.
• When the hot water temperature is adjusted using thermostat-controlled water mixing valves, set
the temperature on the remote controller to about 10
°
C higher than that required to ensure the
appropriate temperature.
When setting high temperatures (60 - 80
°
C);
Please switch to the priority setting if the temperature
cannot be adjusted
(when an additional remote controller is attached)
.
Here
Here
Here
(Eg.: 60
°
C)
Flashing
Temperature
Display for about
10 seconds to
Temperature on.
(Eg.: 40
°
C)
