33
33
Operating Instructions
• In order to prevent the screen from burning out, after the remote
controller has not been used for about 10 minutes, the screen
display changes, and continuously scrolls sideways. (
P10,18-19)
The display on the
remote controller
moves continuously.
The power lamp is not lit.
• Has the power been cut?
Problems concerning the remote controls
Poor supply of hot water
• Are the filters at the drain plugs clogged? (
P31)
The volume of hot water
discharged from the hot
water tap varies
Problems concerning volume of hot water
• When using hot water, the volume discharged may decrease when hot
water is used somewhere else. Also depending on the pressure of the
water line and the piping conditions, the volume of hot water discharged
may drastically decrease or even stop. In this, the volume of hot water
discharged will become stable again after waiting some time.
• There are some types of hot water taps that discharges large
volumes of hot water at first but stabilizes after time.
• In order to stabilize the temperature of hot water, the unit controls
the volume of hot water by discharging little at first and discharging
fully when the temperature becomes stable.
Temperature setting
cannot be increased.
• Has the maximum temperature setting been changed? (
P18-19)
• If the power is disconnected for any reason, when the power is
reconnected, the clock on the display screen shows “0:00”,
indicating that it needs to be reset. (
P17)
• If using the remote controller RCS3211, the hot water temperature
display reverts to the factory setting, so please check it.
Clock shows “0:00”.
After the power is cut,
the hot water supply
temperature is different.
