Bosch AUTODOME IP 4000i, Руководство по установке

Страница: 35 / 44

AUTODOME IP 4000i Installing a Pipe Mount and Camera | en 35
Bosch Security Systems Installation Manual 2017.08 | 1.0 | F.01U.xxx.xxx
13 Installing a Pipe Mount and Camera
Notice!
Indoor use only!
This mount shall only be installed indoors. No outdoors installation is permitted.
13.1 Tools Required
– Appropriate tool for cutting a hole in drywall
– No. 2 Phillips screwdriver
– Torx screwdriver, T-25
13.2 Installation Requirements
– The ceiling is thick enough to install the mounting screws.
– The ceiling can sustain at least eight (8) times the weight of the camera (1.88 kg (4.14
lb)): > 15 kg (33 lb).
13.3 Preparing the Ceiling for Installation
1. Determine a secure location for the pipe mount. Ensure there is an adequate opening in
the ceiling or mounting structure for the cables to pass through.
!
Caution!
Select a rigid mounting location to prevent excessive vibration to the camera.
Notice!
The fasteners and mounting surface must be capable of supporting a maximum load of 11.33
kg (25 pounds).
2. Use the direct connect plate as a template to mark the location to drill holes for the four
mounting screws (and anchors (user-supplied) if necessary), and to cut the hole for the
cables.
3. Drill the holes for the mounting screws.
4. Drill a hole (maximum of 20 mm [.79 in.]) in the center of the mounting location to feed
the cables through the mount.
5. Insert the wall anchors (user-supplied), if necessary, into the ceiling at the locations
marked in step 2.
13.4 Installing the Pipe Mount
1. Attach the direct connect plate to the ceiling or mounting surface.
2. Thread the RJ45 cable and 24 VAC cables through the ceiling and then through the
(adapter).
Ensure that the cables are long enough to reach through the mount and the camera’s
mounting cap to the connections from the camera.
1.
Attach the mounting flange and (adapter) to the direct connect plate using four M5
screws.
2. Thread the cables through the pipe mount.
3. Attach the pipe mount to the mounting flange and (adapter).