Bosch AUTODOME IP 4000i, Руководство по установке

Страница: 28 / 44

28 en | Installing a Camera Directly to an Indoor Wall AUTODOME IP 4000i
2017.08 | 1.0 | F.01U.xxx.xxx Installation Manual Bosch Security Systems
11 Installing a Camera Directly to an Indoor Wall
11.1 Installation Requirements
– The wall is thick enough to install the mounting screws.
– The wall can sustain at least eight (8) times the weight of the camera (1.88 kg (4.14 lb)):
> 15 kg (33 lb).
11.2 Preparing the Wall for Installation
Notice!
Indoor use only!
The instructions in this chapter apply to indoor installation only. For outdoor installation, use
either the surveillance cabinet (NDA-U-PA
x ) or the mount plate (NDA-U-WMP).
1. Determine a secure location for the wall mount. Ensure there is an adequate opening in
the wall for the cables to pass through.
2. Use the direct connect plate as a template to mark the location to drill holes for the four
mounting screws (and anchors (user-supplied) if necessary), and to cut the hole for the
cables.
3. Drill the holes.
4. Insert the wall anchors (user-supplied) (if necessary) into the wall at the locations
marked in step 2.
5. Cut an appropriately-sized hole for the cables, using a drywall utility saw or jig saw.
11.3 Installing the Wall Mount
1. Attach the direct connect plate to the wall.
2. Thread the RJ45 cable and 24 VAC cables through the wall and then through the
(adapter).
Ensure that the cables are long enough to reach through the mount and the camera’s
mounting cap to the connections from the camera.
1.
Slide the mounting flange over the wall mount.
2. Attach the wall mount to the mounting flange and to the direct connect plate using four
M5 screws.
3. Attach the wall mount to the mounting flange and fix them on the front door of the Wall-
mount Surveillance Cabinet by using four M5 screws.
11.4 Attaching the Camera to the Pendant Interface Plate
1. Install the pendant interface plate mount onto the end of the wall mount or the pipe
mount.
2. Attach an M5 screw and the L-shaped end of the safety tether to the stand-off on the
pendant interface plate mount with the T25 Torx screwdriver.
3. Attach the M4 screw to the ground point on the pendant interface plate mount with the
T25 Torx screwdriver.