Bosch AUTODOME IP 4000i, Руководство по установке

Страница: 36 / 44

36 en | Installing a Pipe Mount and Camera AUTODOME IP 4000i
2017.08 | 1.0 | F.01U.xxx.xxx Installation Manual Bosch Security Systems
4. If you choose to install the pipe mount extension, thread the cables through the
extension. Attach the pipe extension to the open end of the pipe mount.
5. Attach the hook at the end of the Safety Tether to the loop attached to the top of the
camera.
6. Connect the mating connectors from the user-supplied cables from the pipe to the
matching connectors from the camera. Refer to the chapter Connection for more
information.
7. Place the top of the camera inside the mounting cap.
8. Rotate the camera approximately 15 degrees in a clockwise direction to lock firmly into
place.
9. Secure the safety locking screw with the T15 Torx screwdriver.
13.5 Attaching the Camera to the Pendant Interface Plate
1. Install the pendant interface plate mount onto the end of the wall mount or the pipe
mount.
2. Attach an M5 screw and the L-shaped end of the safety tether to the stand-off on the
pendant interface plate mount with the T25 Torx screwdriver.
3. Attach the M4 screw to the ground point on the pendant interface plate mount with the
T25 Torx screwdriver.
M4
T25
T25
M5
4. Route the cables from the ceiling out of the side of the mounting plate with the crescent-
shaped cut-out.
5. Attach the metal mounting plate to the inside of the pendant interface plate mount with
the three (3) M4 screws. Orient the plate as indicated in the following figure.