Bosch AUTODOME 4000 mini, Руководство по эксплуатации

Страница: 27 / 90

Notice!
To prevent scratches on the dome cover, Do Not Remove the
plastic film protecting the dome cover until after hardware
installation is complete.
8. Remove the white foam ring from the camera base, and
remove the white foam sheet from the inside of the dome
cover. (These are for protection during transport.)
9. Align the four screw holes on the camera base (item 3) with
the four plastic anchors.
!
Caution!
When (re)mounting the camera base, make sure that each
mounting screw has a rubber O-ring. This ensures protection
against water ingress.
10. Attach the camera base to the ceiling using the four #8 x 32
screws (with O-rings attached) (item 4). Tighten the screws
enough to ensure that the camera base is secured to the
ceiling.
11. Make the necessary Dip Switch settings (described in
chapter 4.3). Note: This step can also be done later, but
then the dome cover must be re-opened.
!
Caution!
When (re)mounting the dome cover to the camera base, make
sure that each screw has a rubber O-ring, and that the large
rubber O-ring is in place on the camera base. This ensures
protection against water ingress.
12. Align the screw holes on the dome cover (item 6) with the
camera base.
13. Attach the dome cover to the camera base using the four
M4 x 12 Torx screws (with O-rings (item 4) attached) using
the supplied Torx wrench. Make sure that the large rubber
O-ring between the camera base and dome cover is in place
AUTDOME 4000 Mini
PTZ Dome
Installing a Surface Mount | en 27
Bosch Security Systems, Inc. 2013.4 | |