Bosch AUTODOME 4000 mini, Руководство по эксплуатации

Страница: 8 / 90

Important notices
!
Caution!
A regulated 24 VAC, 43W power supply is recommended for use
with this camera for the best picture and the most stable
operation. An unregulated power supply can cause damage to
the camera. When unregulated power supply is applied,
product warranty will be void.
Bosch recommends using the camera with a monitor that has a
CCTV-quality 75 Ohm video impedance level. If your monitor is
switched to high impedance, please adjust accordingly.
Do not attempt to disassemble the camera to gain access to the
internal components. Refer servicing to your dealer or to
qualified service personnel.
Never face the camera towards the sun or any bright or
reflective light. This may cause smear on the picture and
possible damage to the CCD.
Do not remove the serial sticker for the warranty service.
All-pole power switch - Incorporate an all-pole power switch,
with a contact separation of at least 3 mm in each pole, into the
electrical installation of the building. If it is needed to open the
housing for servicing and/or other activities, use this all-pole
switch as the main disconnect device for switching off the
voltage to the unit.
Camera grounding - For mounting the camera in potentially
damp environments, ensure to ground the system using the
ground connection of the power supply connector (see section:
Connecting external power supply).
Camera lens - An assembled camera lens in the outdoor housing
must comply and be tested in accordance with UL/IEC60065.
Any output or signal lines from the camera must be SELV or
1.3
8 en | Safety
AUTDOME 4000 Mini
PTZ Dome
2013.4 | | Bosch Security Systems, Inc.