English |
25
Bosch Power Tools
F 016 L70 839 | (6.7.11)
Pole cart (accessory or supplied with
“Grass Shear & Pole Cart”)
f
The pole cart is designed only for use with
the grass shear at ground level.
f
Do not use the pole cart with the shrub
shear or above ground level.
Removing Pole Cart (see figure B)
n
Unplug the handle connector
12
.
o
To release the garden product from wheel
cart
14
, pull the garden product in the direc-
tion shown.
Fitting Pole Cart (grass shear only)
Align the grooves on the garden product with
fixing on the wheel cart
14
.
Plug in the handle connector
12
.
Adjusting Handle Length (see figure C)
n
Loosen the adjustment collar
11
.
o
Pull the telescopic pipe
10
out to increase
the height, or push it in to decrease the
height.
p
Re-tighten adjustment collar
11
.
Adjusting for Edging Mode (see figure D)
Turn the garden product 90 °, in either direction
to position the garden product in the vertical
edging mode.
Operation
Initial Operation
Switching On (see figure E)
n
Dis-engage the safety lock
3
by moving the
button as shown.
o
Then press the On/Off switch
7
and keep it
pressed.
Switching Off
Release the On/Off switch
7
.
Engage the safety lock
3
by moving the button
as shown.
Battery Charge-control Indication
The battery charge-control indicator
2
indicates
the charge condition of the battery for a few sec-
onds when the On/Off switch
7
is pressed
through halfway of fully.
Working Advice
f
Hold the garden product away from your-
self. Stand in a secure and stable position.
f
For more tips on cutting please refer to
website www.bosch-garden.com.
Anti Blocking (shrub shear only)
The garden product has a patented feature
which works as follows:
If the blade stalls on a tough material, the load
of the motor increases. The intelligent micro-
electronics senses this overload condition and
repeatedly reverses the motor, in order to pre-
vent stalling and to cut the material through.
This audible reversing cut action continues for
up to 3 s.
After cutting through, the garden product con-
tinues in its normal mode, or in case the over-
load condition continues the blades automati-
cally stop in the open position (e. g. in case a
piece of metal fence accidentally blocks the gar-
den product).
Cutting Hedges (shrub shear only)
Before cutting check the hedge for foreign ob-
jects e. g. wire fences.
Cut stems up to 8 mm in thickness. When cut-
ting, move steadily along the line of cut, so that
stems are fed directly into the cutter blades.
The double edge of the cutting blade enables
cutting to either direction, or with a side to side
motion.
After use replace the blade transport guard.
LED
Capacity
Continuous lighting, green
≥
35%
Flashing light, green
15 – 35%
Flashing light, red
5 – 15%
Continuous lighting, red
≤
5%
OBJ_BUCH-1077-004.book Page 25 Wednesday, July 6, 2011 9:54 AM
