English–2
1 609 929 H74 • (05.03) T
Please open the foldout page with the illustration of the unit and leave
it open while you read these operating instructions.
The numbering of the product elements refers to the illustration of the
unit on the graphic page.
1
Screw
2
Wheel
3
Display
4
Display lighting button
5 “on/off”
button
6 “start”
measurement button
7
Handle
8 “mode”
button
9
Aligning aid
10
Sensor area
11
Battery compartment cover
12
Battery compartment latch
13
Serial number
14
Protective bag
The unit is intended for searching for objects such as, for example, re-
inforcing metal, plastic pipes, lines and cables in concrete as well as the
indication of the depth of the objects found.
■
Protect the unit from moisture and direct sunrays.
■
In order not to influence the measured results, no stickers or name-
plates may be attached to the sensor area
10
on the back of the
unit, especially nameplates of metal.
■
If the unit is not used for a long period, the batteries must be re-
moved (danger of corrosion).
■
Transport and store the unit in the protective bag
14
.
Use alkali-manganese or rechargeable batteries exclusively.
To open the battery compartment cover
11
, press the latch
12
in direc-
tion of the arrow
(a)
and lift up. Remove the battery compartment cover
(b)
. Insert the batteries provided. (See the illustration on the fold-out
page.)
When inserting the batteries, pay attention to the correct polarisation.
When the small battery symbol
ap-
pears in the upper left of the display, the
unit can still be operated for approx.
30 min when using alkali-manganese bat-
teries (shorter period for rechargeable
batteries).
If the indication shown here appears in the
display, the batteries must be replaced.
Measurements are no longer possible.
Always replace the complete set of bat-
tery. Use only batteries of a single manu-
facturer with the same capacity.
Product Elements
Intended Use
Protection of the Unit
Inserting/Replacing the Batteries
dtectc_bu_1609929H74_t.fm Seite 2 Montag, 21. März 2005 1:49 13