Bosca SPIRIT 500 Pellet, Инструкция по установке и эксплуатации

Страница: 23 / 69

If vacuum is used to clean your unit, we suggest using a vacuum designed for ashes. (We recommend LoveLess Ash Vac, 1-800-
568-3949 Ext. #27)
Some regular vacuums and shop vacs leak ash into the room. Your vacuum or shop vac may have a special filter or bag available
to eliminate this leakage.
VACUUM USE
CLEANING
fig. Nº21
Heat Exchanger Tubes: Your BOSCA SPIRIT 500 Pellet stove is
designed with a built-in heat exchange tube cleaner. The cleaner
rod is located in the grill above the stove door.This should be
used every two or three days to remove accumulated ash on the
tubes, which reduced heat transfer on the stove.
Move the cleaner rod back and forth several times to clean the heat exchanger
tubes. Be sure to leave tube cleaner at the rear of the stove (refer to fig. Nº20).
Interior Chambers: Two doors in the firebox shaped like
rain drops can be opened for periodic cleaning (refer to fig. Nº21).These
doors allow access to the chamber surrounding the firebox.
P e r i o d i c a l l y , y o u m u s t v a c u u m a s h e s f r o m t h i s c h a m b e r .
In some cases you will need to remove creosote, which can
accumulate rapidly under certain conditions. A small wire brush can be
used. It is important to remove this creosote because it is highly
combustible.
INSPECT BEHIND THESE CLEANING PLATES AT LEAST ONCE PER TON OF PELLETS
BURNED UNTIL YOU ARE FAMILIAR WITH HOW ASHES AND CREOSOTE
ACCUMULATE WITH YOUR OPERATING PRACTICES.
CAUTION: DO NOT VACUUM HOT EMBERS OR ASH
fig. Nº20
PULL
PUSH
OWNER´S MANUAL
-22-