Borg & Overstrom b2, Инструкция по установке и эксплуатации

Страница: 9 / 32

Install & Operation Manual Borg & Overström GB 9
Sanitisation Guide
NOTE:
Before beginning the sanitation process please ensure that water is turned off at the mains and refer to the MSDS
document for further information. Use bioguard hand gel and ensure gloves are worn.
1 2 3 4
5 6
7
8
Briefly press chilled/ambient
dispense buttons to release
internal water pressure from
the machine.
Remove the existing filter. Add 25 ml of Bioguard
Internal Sanitisation fluid to a
clean and empty service filter
cartridge.
Connect to machine.
Turn on incoming water, allow
service cartridge/doser to fill.
Dispense water using the
chilled button until the water
appears pink. Briefly press the
ambient button too.
Leave the solution inside
machine for sanitisation
(minimum 5 minutes) while
thoroughly cleaning the
machine externally, pay
particular attention to the
dispense faucet and buttons.
Remember to include the drip
tray. If a Waste Overflow
System is fitted, empty this
and flush through with a small
amount of sanitisation fluid if
needed.
PINK
For reservoir variants always ensure that the hot water outlet is plugged before beginning this procedure (use gloves). Never push
the hot water button during the sanitisation procedure.
1 2 3 4
Remove the top panel by
undoing 2x screws at the rear
of the dispenser.
Remove the polystyrene lid.
Gently lift the plastic lid from
the tank, taking care not to
disconnect the plumbing.
Dispense chilled water until
the baffle plate is accessible.
Insert the Hot tank sanitisation
plug into the centre of the hot
tank, press down firmly. Refit
the plastic lid to the tank.
Follow steps 1-12below.
Once the sanitisation procedure is complete repeat step 3 and reverse step 4 above, then remove the Hot tank sanitisation plug
and replace the plastic lid firmly on the tank, then replace the polystyrene lid and top panel. Ensuring the screws are done up
before leaving.