Borg & Overstrom b2, Инструкция по установке и эксплуатации

Страница: 11 / 32

Install & Operation Manual Borg & Overström GB 11
Advanced Troubleshooting
Fault Diagnosis: No Water Dispenses
Problem/Report Possible Cause Suggested Action
From Ambient Tap Water Supply turned off (and tank
empty).
Check all that taps/valves/ filters
on the incoming supply are fitted
and are turned on.
“Waterblock” tripped off (and tank
empty).
Reset “Waterblock” (and check for
any leaks).
“Leak detector” (if fitted) tripped off
(and tank empty).
Disconnect the power and water
supply, reset the machine (check
for leaks).
Tap not working (and tank full). Dismantle and check the tap,
completely replacing the tap or just
the washer as necessary.
Reservoir Float Valve jammed (and
tank empty).
Replace/adjust position/repair as
needed.
Blocked tank outlets/pipes. Check and unblock or replace as
needed.
From Cold Tap Firstly all as for Ambient Tap. Carry out checks and actions as for
ambient tap.
Chiller tank frozen – Thermostat set
too low.
Thaw out the machine and increase
cold water temprature.
Chiller tank Frozen - Thermostat not
working.
Thaw out the machine and check
thermostat. Replace Cold Water
thermostat as needed.
From Hot Tap Firstly all as for Ambient Tap. Carry out checks and actions as for
ambient tap
Airlock in dispense pipe work. Unblock/replace hot water pipe
and hot vent pipe. (Check water
level showing in hot vent pipe).
Tank filled with limescale. Replace tank.