bora PKAS3AB, Руководство по установке

Страница: 17 / 28

EN
17
Installation
www.bora.com
4
3
2
1
Fig. 4.29 Mounting bracket – left side (surface mounting)
[1] Worktop thickness lettering (in mm)
[2] Cut marks (x 4)
[3] Fastening lugs (2 on each side)
[4]
Marking for surface mounting
i
The symbols on the mounting brackets show which side
to use for surface mounting and which to use for flush
installation.
i
The lettering shows the cutting mark corresponding to
the worktop thickness.
X
X
If necessary, shorten the mounting brackets according to the
thickness of the worktop.
X
X
To do this, cut the mounting brackets at the appropriate cut
marks using a utility knife.
X
X
Depending on the installation type, turn the mounting brackets
to the left or right (flush installation or surface mounting).
Securing the cooktop extractor
i
The cooktop extractor is secured using the 4 mounting
brackets provided, for which there are 4 alternative
positions on the holding plate.
2 3 1
Fig. 4.30 Pushing on the mounting brackets
[1] Alternative position for mounting bracket
[2] Mounting bracket
[3] Cooktop extractor
X
X
Push the mounting brackets [2] into the holders provided on
the cooktop extractor [3] or the alternative positions on the
holding plate [1].
Fig. 4.31 Tightening the mounting clamps
X
X
Use a Torx 20 screwdriver to tighten the mounting brackets
slightly from underneath.
X
X
Verify that the alignment is correct.
4.9 Installing the duct system
4.9.1 Duct connection dimensions
245
294
89
126
Fig. 4.32
Duct connection dimensions for PKA3/PKA3AB with
the curved duct piece