bora BHA, Инструкция по эксплуатации и сборке

Страница: 33 / 44

EN
33
Operation
www.bora.com
7.4 Saving energy
X X
Follow all of the energy-saving tips to use the cooktop
with integrated cooktop extractor in an energy-efficient
manner.
X X
When purchasing cookware, pay attention to the
diameter of the base. Usually the upper diameter of
the pot is given. The diameter of the base is often
smaller.
X X
Use pressure cookers. Due to the closed cooking
chamber and the overpressure, pressure cookers save
the most time and energy. The short cooking time
helps preserve vitamins.
X X
Make sure there is sufficient liquid in the pressure
cooker. An empty pot which is still being heated can
lead to overheating. The cooking zone and the pot may
be damaged by overheating.
X X
If possible, always close cookware using a suitable lid.
X X
Choose a suitable size of cookware commensurate
with the amount of food you are cooking. A big pot
that is barely filled requires a lot of energy.
7.2.3 Switching on the delayed automatic
after-run
X X
Continue pressing until fan level
n
for delayed
automatic after-run is shown.
The fan runs in level 1 and switches off automatically
after 10 minutes.
7.2.4
Switching off the cooktop extractor
X X
Press and simultaneously until the fan level
indicator
0
is displayed,
or
X X
press or several times until the fan level
indicator
0
is displayed.
When the fan level indicator displays
0
, the cooktop
extractor is switched off automatically after a few
seconds.
7.3 Pay attention to the filter service
display
If the fan level indicator displays
F
(F = filter service
indicator), this means the activated charcoal filter is used
up (for recirculated air only) and the stainless steel grease
filter needs an overhaul.
If you do not wish to do the filter change yet, e.g. if you
only cook occasionally:
X X
Press or to go into the normal operating mode.
0
is shown in the fan level indicator.
Changing the filter
X X
Switch off the cooktop with integrated cooktop
extractor.
X X
Observe all warnings that are described in the Cleaning
chapter.
X X
Replace the activated charcoal filter.
X X
Clean the stainless steel grease filter, the air inlet nozzle,
the air guiding housing and the housing base.
Resetting the filter service display
If the activated charcoal filter was replaced (only for
recirculated air) and the stainless steel grease filter was
cleaned, it will be necessary to reset the filter service
display.
X X
Switch on the cooktop with integrated cooktop
extractor.
The fan level indicator shows an
F.
X X
Press and simultaneously for at least three
seconds until a
0
flashes in the air level indicator.
After a few seconds,
0
will be displayed permanently.
The filter service display has been reset.