bora BHA, Инструкция по эксплуатации и сборке

Страница: 18 / 44

EN
18
Device description
www.bora.com
5.5.3 Overheating protection
INFO If the cooktop overheats, the power is reduced or
the cooktop is switched off completely.
The device is fitted with overheating protection. The
overheating protection can be triggered if:
Q Q
Cookware is heated up empty.
Q Q
Oil or fat is heated on high power.
Q Q
A hot cooking zone is switched on again after a power cut.
Whilst the overheating protection is active, one of the
following steps is taken:
Q Q
The activated power setting is switched back to the
previous level.
Q Q
The power setting P can no longer be switched on.
Q Q
The set power level is reduced.
Q Q
The cooktop switches off completely.
After a sufficient cooling period, the cooktop can be used
again in full.
5.5.4 Automatic switch-off if the button is
pressed and held
The cooktop will be switched off automatically when
one or more sensor buttons are touched for longer than
10 seconds (finger contact, objects, soiling).
Q Q
The display shows
ER03
.
Q Q
After a few seconds, the cooktop will switch off.
X X
Remove the finger or object from the cooktop.
X X
Clean the cooktop as required.
X X
Where necessary, switch the cooktop back on.
5.5.5 Child safety lock
The child safety lock prevents the cooktop from being
switched on automatically. The child safety lock can only
be activated when the cooktop is switched on and all
cooking zones have been switched off (see the Operation
chapter).
5.4.3 Filter service display
The filter service display becomes active after the cooktop
extractor has operated for 150 hours. The activated
charcoal filters have reached the end of their service life
(with recirculation only) and the stainless steel grease
filter needs to be thoroughly cleaned.
Q Q
A flashing
F
is displayed in the filter service display.
Q Q
The filter service display is shown every time the
cooktop extractor is switched on and remains active
until the filter has been changed and the filter service
display is reset.
Q Q
The cooktop extractor can still be operated without
limitations.
5.5 Safety devices
5.5.1 Residual heat display
INFO While
H
is displayed in the cooking zone indicator
(residual heat display), do not touch the cooking
zone or place any heat-sensitive objects on top of
it. Risk of burns and fire!
After switching it off, the cooking zone remains hot.
H
is displayed in the cooking zone indicator (residual heat
indicator). The cooking zone indicator will go out after
sufficient cooling time (temperature < 60°C).
5.5.2 Safety shut-down
Cooking zone
Each cooking zone is switched off automatically when the
cooking zone exceeds the maximum operating duration at
a power level (see table 4.3).
H
(residual heat display)
is then displayed in the cooking zone indicator (see the
Device description section).
Power level
1 2 3 4 5 6 7 8 9
Switch off after
x hours
6 6 5 5 4 1.5 1.5 1.5 1.5
Tab. 5.4 Overview of the safety shut-down
X X
Switch the cooking zone back on (see Operating
control) if you want to put the cooking zone back
into operation.
Cooktop extractor
The cooktop extractor switches off automatically if no
buttons are pressed for 120 minutes.