12
13
Installation
Fig. 1
Cover
Cold
Hot
During and after installation protect the outer parts of the valve to avoid damage to
plated surfaces.
Place the covers over the copper pipes, followed by the nuts and the olives.
Push the valve onto the copper pipes and the mounting plate, tighten both the nuts on
the inlets being careful not to damage the plated surface.
Drill the marked holes to a suitable
depth for the wall plugs and secure with
supplied screws.
If you are fitting the valve to a partition
wall or a wall of particularly soft
substrate you will need specialist fixings.
Mounting plate
Screws
Wall plugs
Nut
Olive
Inlet pipe
Installation
Secure the valve into position by
tightening the three grubs crews, one
at 12 o'clock and the other two at 4 and
eight o'clock
Hex key
Place the washer into the nut and screw
the short riser to the diverter and tighten
being careful not to damage the chrome
surface.
Grub screw
Short
riser
Washer
Diverter
Hose
connection
Hex key
