33
33
MANAGE Mode
33
Calibrate
To calibrate, the Power sensor must be turned on, then connected and paired. If
the NODE is currently showing CALIBRATE?, start with Step 4.
1. Enter MANAGE mode. Hold
B
for three seconds.
The Manage mode starts with the Bike Selection display.
2. Browse
s 1
to power.
3. If needed, change Power to On. Press
s 2
to change.
Press
s 1
to save.
Hold
B
for three seconds to return to RIDE mode.
Perform a Force Pair: hold
s 1
and
s 2
for three seconds and make each
sensor send a signal.
Wait for the Force Pair to complete, then repeat step 1 and step 2.
4. If needed, change Calibrate? to Yes. Press
s 2
to change.
To save your choice and proceed to the calibration process, press
s 1
. When
the “Calibrating Power” shows on the screen, do one of the following:
For a Powertap power sensor, spin the wheel
For a SRM power sensor, spin the crankset backwards with no weight on the pedals
For a Quarq power sensor, do not spin the crank
5. If the calibration fails, the screen reverts to Calibrate? (step 4). Refer to
Troubleshooting on page 52.
If the calibration process passes, the Node goes to the Heart Rate screen.
Choose one of the following:
• Follow the instructions to manage Heart Rate on page 34.
• To see other functions, browse
s 1
.
• To return to RIDE mode, hold
B
for three seconds.
1.
3.
B
(3 seconds)
2.
s2
s2
s1
s1
4.
s1
