8
8
Setup (Initial Programming)
The NODE is shipped with the battery outside the computer so that the battery
is fresh. When you install the battery, your NODE will automatically proceed
through this Setup, including the Pairing process and Connecting procedures.
The automatic Setup also happens when you replace the battery or perform the
Reset procedure. Read this entire page before proceeding.
Before you start Setup
Before starting the Setup, complete the installation of the computer bracket,
sensor, and magnet (for a sensor, see the installation instructions that are
packaged with the sensor). Install the battery and place the NODE within 5 feet
(1.5 m) of the sensor, and be ready to activate the sensor as explained in the
next section.
Pairing Sensors
“Pairing” is a process used by the computer to identify the signal from a sensor
(Figure 18). This process happens at the end of the initial setup. When a sensor
is paired, its icon appears on the screen (Figure 19).
For the computer to find and pair to the sensor, the sensor must send a signal.
The speed sensor only sends a signal when the wheel rotates.
Installing the Battery
1. Insert the supplied battery with the ‘+’ facing up or out.
2. Attach the battery cover. Turn the cover clockwise with a coin.
Figure 18. Pairing onto Radio Signals to Identify Sensors.
Figure 19. Icons Indicate Sensors that are Connected.
Sensor icons
2.
1.
