7
04/2013
6. Attach the upper door hinge by using the screws at the opposite side, after you unscrewed the
hinge pin and screwed it on at the other side of the door hinge again.
Put the in point 1 removed device cover on again, tight the screws and clip the cover caps on.
7. Affix the door handle at the opposite side by loosening the screws of the handle, take the cover
caps from the door and screw on the handle at the below holes. Put the cover caps on the exposed
holes at the other side.
Check if the door is arranged vertical as well as horizontal, so that a smooth opening and closing of
the door is ensured.
S
TARTUP
/
O
PERATION
Prior to first use
ATTENTION
After transport, the device should be left standing for 4 hours in order for the oil to be collected in the
compressor.
Nonobservance could cause damage to the compressor and hence result in failure of the
device. This would void your warranty claim.
•
Clean the interior of the device including all accessory parts located inside.
Connect the device to the mains supply
IMPORTANT
•
The device must be earthed properly. For this purpose the plug of the mains cable has been fitted
with the intended lead.
•
Contact an electrician if the plug does not fit in the wall socket.
•
In case you disconnect the device or in case of power failure: Wait for 5 minutes before restarting
the device.
Turning on
Turn on the device by connecting the plug to a wall socket. At the temperature control, located on the
control panel at the device front, you can adjust the desired temperature. Please also refer to the
chapter “Control panel settings“.
Control panel & settings
The control panel that controls the temperature inside the freezer compartment is located inside:
Adjustable thermostat
Setting Cold (min):
lowest setting (warmest inside temperature)
Setting Colder (max): highest setting (coldest inside temperature)
