10
04/2013
T
IPS
F
OR
E
NERGY
S
AVING
•
Disconnect the plug if you do not use the device.
•
Do not install the device near stoves, heaters or other heat sources. In case of higher ambient
temperatures, the compressor will run more frequently and longer.
•
Ensure sufficient ventilation at the bottom and rear side of the device.
Never block any ventilation openings.
•
Allow warm dishes to cool down before putting them in the device.
•
Do not open the door longer then necessary.
•
Avoid opening all freezer compartments at the same time.
•
Make sure that the temperature in the freezer does not rise above -18°C.
•
The device should be defrosted regularly.
•
Always keep the condenser – metal grid on the rear side (if existing) – clean.
•
Make sure the door sealing is in good order for the door to close properly.
M
AINTENANCE
A
ND
C
LEANING
Cleaning and care
For hygienic reasons, clean the interior and accessory parts regularly.
WARNING
•
Always disconnect the plug or turn off/ unscrew the fuse before cleaning. Pull the plug and not the
cable.
•
Does not use steam cleaners for cleaning the device; moisture could enter electrical components.
Risk of electric shock! Hot steam could damage the plastic parts. The device must be dry before
restarting operation.
•
Essential oils and organic solvents, such as the juice of lemon or orange skin, butanoic acid or
cleaning agents containing acetic acid can damage plastic parts. Prevent contact of any part with
such substances. Do not use abrasive cleaning agents.
Pls. do as follows:
•
Remove all food and keep covered at a cool location.
•
Use warm water and a mild detergent for cleaning the interior (including rear side and bottom).
•
After thorough drying, restart operation.
•
Clean the condenser - metal grid on the rear side (if existing) once a year, using a soft brush or
vacuum cleaner.
WARNING
Do not bend the cooling coils.
Do not use arenaceous abrasives.
Repairs
WARNING
Servicing of electric devices must be conducted by qualified experts only. Incorrect or improper repairs
constitute a risk for the user and will void the warranty!
What if . . . Troubleshooting
The design of the device ensures a trouble-free operation as well as a long life cycle. Nevertheless, if
any defect occurs during operation, please check if it is caused by improper operation.
The following problems can be solved by you by checking for the possible cause.
PROBLEM
POSSIBLE CAUSE
SOLUTION
The device is
not working
properly or at
all
Is the plug securely connected to the
mains? Has the safety mechanism of the
wall socket been triggered?
Is the temperature control properly set?
Is the place unqualified?
Connect the plug properly to the socket,
turn on the fuse, and contact a technician if
necessary.
Check the settings.
Check the ambient temperature.
