Bolton Tools BT1337G, Руководство оператора

Страница: 4 / 49

1. SPECIFICATION
(1) Swing over bed 12.99
〞
(2) Swing over gap 19.09
〞
(3) Swing over saddle 8.46
〞
(4) Distance between centers 37
〞
(5) Length of bed 58
〞
(6) Width of bed 7.17
〞
(7) Hole through spindle 1.5
〞
(8) Tailstock barrel travel 3.94
〞
(9) Cross slide travel 5.91
〞
(10) Tool slide travel 3.54
〞
(11) Saddle travel 33.46
〞
(12) Taper of spindle hole M.T.5
(13) Taper of tailstock barrel M.T.3
(14) Range of spindle speed 9steps 64-1500RPM
(15) Diameter of lead screw 0.87
〞
(16) Diameter of feed rod 0.75
〞
(17) Thread of lead screw 8T.P.I.(inch)3mm( metric)
(18) Thread can be cut inch 14kinds 7.5-48T.P.I. metric 11 kinds 0.5-3mm
(19) Motor power 1.5HP
(20) Net weight with/without stand 858lb/726lb
(21) Packing size without stand 70.08
〞
×29.13
〞
×29.53
〞
(22) Packing size of stand 28.35
〞
×11.81
〞
×27.56
〞
(23) Noise <83dB
2. STANDARD ACCESSORY
(1) Tool post wrench (2) Double end wrench 14-17 (3) Allen wrench 3
㎜
, 4
㎜
, 5
㎜
, 6
㎜
,
8
㎜
(4) Screw driver 6×100 (5) Center M.T.3 (6) Center sleeve M.T.5/M.T.3 (7) Oil gun
(8) Follow rest (9) Steady rest (10) Change gears (11) Three jaw chuck (12) Tool box
3. OPTIONAL ACCESSORY
(1) Machine stand (2) Four jaw chuck (3) Face plate (4) Live center
4. ELECTRICAL SYSTEM
Standard lathe is wired for 220V, single phase 50 cycles; other connections can be made
as customers’ requirements.
The electrical system in the lathe has been installed and adjusted in the factory. Please
don’t open the electrical box. Before operating, wire the proper power source to the lathe
and connect the ground wire. Turn on the power and check the running direction of the
spindle. If wrong, turn off the motor and cut the power source, then change the wires as
the wiring chart.