Bolide Technology BC2002-AT88, Руководство пользователя

Страница: 14 / 38

-12-
1. System Setup
Main menu • System Setup
1.1 Device Information
Main menu • System Setup • Device Information
1. System ID:
Identifies the current system
’
s
ID number. Each system has its unique ID ranging from
001 to 255
(255 is default broadcast ID ). The System
ID can be set only when DIP switch is in Programmable
ID mode.
Device Information
====================================
1.System ID :001
2.Title :A
3.Title :B
4.Broadcast ADD :255
5.System Time :00:00
6.System Date(DD-MM-YY):05-01-00
7.Auto Restart
:00:00
8.Back
0.Exit
System Setup
====================================
1.Device Information
2.Display Configuration
3.Change Password
4.Language Select
5.Factory Default
6.System Restart
7.About
8.Back
0.Exit
Enter S/N: 6161310854
====================================
1.Input[0000000000]
2.Back
====================================
Numeric (Zoom Shift)
To set the system ID:
1.Move the cursor to select INPUT from System ID
.The
INPUT
setting will flash as the following picture
shown.
2.Move the joystick to the right and enter the serial
number to be displayed for the
“
Enter S/N
”
setting.
3.Move the joystick up or down to select the figure,
and move it to the left to save the setting.
4.Move the joystick to the left or right to quit this
editing.
5.Select BACK to return to the previous menu.
Tip : Move the joystick clockwise or anti-clockwise to
select upper case, lower case and numeric input.
NOTE:
1.If the S/N is not identical with the original one,
the following picture will pop out.Please repeat step
1 through step 5.
----------------------------
Error S/N
---------------------------
2.If the OSD menu will pop out as below,try to
reset the system ID. That is because the system ID
is not identical with the setting.Thus the system can
not be controlled.
ID SET TO 2
Call Preset 1 to Confirm
3. After correct the system ID , call preset No.1 to
confirm the resetting .
4.If the OSD menu is appeared as below, it means
that the current ID is hard address and cannot be
programmed. You should set all 8 bits of SW1 ON to
activate programmable address.
----------------------------
Address Fixed By DIP
---------------------------
2.Title:
Set the first 10 characters of the system name.
Please refer to page 11.
3.Title: Set the second 10 characters of the system
name.Please refer to page 11.