Bogen ORATOR, Руководство пользователя

Страница: 17 / 20

13
OMX1 MIC/Transmitter Features
(contʼd)
LANYARD
LANYARD
PLATE
TOP SLAT
BOTTOM
SLAT
ROUND
HOLE
TOP HOLE
LANYARD
LANYARD
PLATE
BELT
CLIP
TAB
SIDE
VIEW
REAR
VIEW
(1) Feed Lanyard into Top Slat on the Lanyard Plate, then
back out through the round hole.
(2) A. Start feeding the Lanyard plate so that the top of the
plate is under the Belt Clip but the rest of the plate is
above the Belt Clip.
B. Then slip the Belt Clip through the Bottom Slat of the
Lanyard Plate so that the bottom end of the plate is
against the transmitter and underneath the Belt Clip.
C. Continue to slide the Lanyard Plate up until the top
hole in the plate snaps over the Tab at the top of the
transmitter.
(3) Slip the lanyard and OMX1 over your head and adjust
the OMX1ʼs position by sliding it up or down the
lanyard. The proper position for the OMX1 on the
lanyard is to have the top approximately the width of
your hand below your chin. Bottom of the lanyard may
need to be held when sliding the pendant up.
NOTE: The break-away clip must be positioned at the
back of the neck and is provided to ensure the
lanyard will not become a strangulation hazard.
It is not designed to be used as a means of
attaching the lanyard around your neck.
Setup for OMX1 Pendant Use
The figures to the right show how to properly assemble
the Lanyard and Lanyard Plate onto the rear of the OMX1
and how to best position the unit when worn.
OMX1 Adjustable Lanyard Assembly
Position at Back
of the Neck
SIDE
VIEW
1
2
3
B
A
C