Bogen ORATOR, Руководство пользователя

Страница: 12 / 20

8
ORB35 Receiver/Base Unit
Controls & Indicators
Power Switch (Front)
The soft touch power switch turns the ORB35 Receiver/Base Unit on and off. A green
indicator ring around the power switch indicates that the Orator is powered on. This indicator
is extinguished when the Orator is off. Charging and communication between OMX1
MIC/Transmitters still continue when the ORB35 is powered off.
AUX 1 – 4 Level Controls (Front)
Each of the AUX inputs has an associated level control located on the ORB35 unitʼs front
panel to adjust its level and the overall balance with other inputs.
Master Volume Control (Front)
A large Master Volume Control is located on the front of the ORB35 unit. The levels of all
inputs are simultaneously changed by adjustments to this control. However, the confirmation
tone is unaffected by this control.
Bass and Treble Controls (Front)
A Bass and a Treble control are provided on the front of the ORB35 base unit to allow users
to adjust the high and low frequency response of the system.
EQ Bypass Switch (Rear)
To use the EQ, this switch must be in the IN position. When the switch is set to the OUT
position, the slider controls will have no effect, but the Bass and Treble controls on the front
of the unit will continue to work.
6-Band Graphic EQ (Rear)
In addition to the front-mounted bass and treble controls, a rear mounted 6-band graphic EQ
is provided to allow precise control of system tonal response. The EQ bypass switch must
be set to IN for these 6 controls to operate.
Override Level Control (Rear)
Sets the Override Input Level to the mix bus. Detection of override audio for muting other
inputs is done before the control so its setting has no effect on the signal level required to trip
an override.
MIC/Transmitter Level Controls (Rear)
Each OMX1 channel has its own level control located on the rear of the ORB35 unit. The
OMX1 has a local level control. When setting the initial levels, the OMX1ʼs level controls
should be set to 10 and the channelʼs rear level control should be set so that feedback (howl-
ing/squealing) from the OMX1ʼs microphone is not occurring. Users can reduce the level at
the OMX1 itself since this will not result in feedback.
Confirmation Tone Level Control (Rear)
When enabled by the DIP Switch setting, the ORB35 unit will acknowledge that certain
functions were received or triggered by emitting a short confirmation tone over the system
speakers. The confirmation tone level control is provided to trim the level of these tones.
The level of the confirmation tone is not affected by the master volume control.