BodyCraft SW-95.0225-G, Руководство по сборке и эксплуатации

Страница: 24 / 58

24
Elite
Step 8: Install Ab Crunch Cable
1. See Fig. A1: Screw the Bolt-end of the AB CRUNCH CABLE (83) at least one-third of the way into
the threaded receptor welded to the TOP FRAME (4). This Bolt-end is an adjustment point if
needed once all of the cables have been installed. Be sure to tighten the Jam-nut.
⚠
CAUTION
At least one third of the thread must be screwed into the slot.
2. See Fig. A2: Install one 4-1/2” PULLEY (100) into SINGLE PULLEY BLOCK (24) using one 3/8” X
1-3/4” HEX BOLT (134) and one 3/8” NYLA-NUT (170). Tighten. Route the cable down to Pulley A2.
3. See Fig. A3: Install one 4-1/2” PULLEY (100) into the second hole up of ADJ. PULLEY BLOCK
(23) and secure with one 3/8” X 1-3/4” HEX BOLT (134) and one 3/8” NYLA-NUT (170). Tighten.
Continue routing the cable up to the Pulley A3.
4. See Fig. A4: Install one 3-1/2” PULLEY (101) into the CABLE ARM CONNECTOR (19), using one
3/8” X 1-3/4” HEX BOLT (134) and one 3/8” NYLA-NUT (170). Tighten. Continue routing the cable
down to the Pulley A4.
5. See Fig. A5 Install one 4-1/2” PULLEY (100) into the FRONT UPRIGHT (3), using one 3/8” X 109.5L
FLAT PIN BOLT (140) and one M6 X 12L MALE SCREW (147). Tighten. Continue routing the cable
up to and over the top of Pulley A5. Install REMOVABLE END (83A) at A5.
6. Tighten all bolts and nuts.