BodyCraft SW-95.0225-G, Руководство по сборке и эксплуатации

Страница: 21 / 58

21
Step 6: Assemble Seat Back Adjuster and Leg Holder
1. Attach the SEAT BACK ADJUSTER (13) to the FRONT UPRIGHT (3), using one 3/8” X 5-1/4” HEX
BOLT (133), two 3/8” LARGER WASHERS (163) and one 3/8” NYLA-NUT (170).
࣑ ATTENTION
Tighten this bolt until the SEAT BACK ADJUSTER (13) is snug against the FRONT UPRIGHT (3) to
eliminate play. If it does not pivot FREELY, loosen slightly.
2. Insert the SHORTER POP PIN (126) into a hole of the SEAT BACK ADJUSTER (13).
3. Attach the LEG HOLDER (14) (holes facing down), to the SEAT BACK ADJUSTER (13) using two
5/16” X 1/2” SCREWS (150) and two 5/16” WASHERS (165). Tighten.
4. Slide two METAL HINGES (15) (holes facing up), onto the axle welded to the SEAT BACK ADJUSTER
(13), then attach BACK PAD (64) to the METAL HINGES (15) using four 3/8” X 1” HEX THREADED
BOLTS (137) and four 3/8” LARGER WASHERS (163). Tighten.
5. Slide a PLASTIC CAP (104) (domed side first) and FOAM SIDE (65) onto each side of the LEG
HOLDER (14).
6. Secure with ALUMINUM CAPS (105) and 5/16” X 1-1/4” COUNTER ALLEN BOLTS (149) on each
side. Tighten.