BodyCraft Family XPress Pro, Руководство по сборке и эксплуатации

Страница: 22 / 56

22
X2
Step 3: Assembly of the Seats Part 2
1. Assemble the seat back adjuster (23) to rear upright (3) with one bolt (128) and one nut (154).
It may be necessary to tighten this bolt, then loosen just enough to let the seat back adjuster
(23) pivot freely.
L
NOTICE
The longer pop pin (77) should seat in the adjustment holes in the seat back adjuster (23).
2. Slide two metal hinges (24) onto the axle on top of the seat back adjuster (23).
3. Assemble the back pad (104) to the metal hinges (24) with four washers (147) and four bolts
(134).
4. Insert tube (31) into into the seat back adjuster (23).
L
NOTICE
Use window cleaner or water for better sliding of roller pads onto tubes.
5. Moisten two foam pads with foam pad covers (103 & 88) and slide it onto each end of tube
(31).
L
NOTICE
It is recommended to use a rubber mallet.
6. Assemble two washers (66) to both foam pads with foam pad covers (103 & 88) and secure the
pads with two covers (69) by using two screws (157) and two washers (173).
7. Lock tube (31) into place with pre-assembled set screw.
8. Assemble the rear seat frame (21) to the base frame (1) with one bolt (126), two washers (147)
and one nut (154).
9. Assemble the rear seat frame (21) to the rear upright (3) with two bolts (128), four washers (147)
and two nuts (154).
10. Insert the rear seat adjuster (22) to the rear seat frame (21) and lock with locking spring knob
(79).
11. Attach the plug (68) and plug (64) to the rear seat adjuster (22).
12. Assemble the seat pad (105) to the rear seat adjuster (22) with two bolts (133) and two
washers (147).