Bolt
#40. Hex Bolt (M8x60 mm)
[2 Pieces]
#41. Hex Bolt (M8x70 mm)
[2 Pieces]
Washer
#46. Washer (M8)
[2 Pieces]
#55. Arc Washer (M8)
[6 Pieces]
Nut
#48. Nylon Nut (M8)
[4 Pieces]
A.) A-Frame Assembly
Open the pre-assembled A-Frame, which is composed of
Front
Support Tube (#02), Rear Support Tube (#01), Safety Strap with
Buckle (#16)
and
Cross Support Brackets (#03
/5
)
. Make sure
that
two
Cross Support Brackets (#03
/5
)
are fully extended
and firmly
locked in place by pressing down on them.
B.) A-Frame Cover
Slide the
Cover (#15L/15R)
on to the A-Frame Assembly and attach
the Velcro underneath the cover.
C.) Ergonomic Side Rail Assembly
Slide the
/HIW
Ergonomic Side Rail (#07L)
onto the slotted
Rear
Support Tube (#01)
and make sure the bottom of
Left
Ergonomic
Side
Rail (#07L)
is resting on the outer side of the inversion system.
On
the top left side put a
Hex Bolt (#40)
through an
Arc Washer
(#55),
followed by the
Rear Support Tube (#01)
, and
Left
Ergonomic
Side
Rail (#07L)
. Then secure it with an
Arc Washer (#55)
, and a
Nylon
Nut (#48)
. On the bottom of left side put a
Hex Bolt (#41)
through
an
Arc Washer (#55)
, followed by the
Rear Support Tube
(#01)
and
Left
Ergonomic Side Rail (#07L)
. Then secure it with
a
Washer
(#46)
, and
Nylon Nut (#48)
. Repeat this process on the other side.
Hardware Required
Assembly Step 1
A
B
Assembly Instructions
IT9910
Page
5
C
