Body Charger GT8600RF, Руководство пользователя

Страница: 22 / 32

Error Message:
ERROR (Protection procedures description)
When treadmill on “RUN MODE” status, monitor display “E1” and makes “BEEP” sound if treadmill didn’t read
speed signal from motor in 7 seconds.
ERROR1 causes: It’s possible that motor speed sensor cable has been damaged; incorrect installment of position
or the speed sensor cable didn’t be connected correct to motor control board.
The monitor flashes “E6” and makes BEEP sound per second if computer didn’t read VR value from incline motor in 6 seconds.
ERROR6 causes: It’s probably that VR sensor of incline motor has been damaged. Or
2.5pitch of 3 PIN connector didn’t correctly connect to socket of motor control board. Perhaps one of the power cable of incline
motor has been dropped (Power cord; UP with red color, Down with black and COM with white). Above causes could lead incline
motor does not work and VR value unchanging and show E6.
●
ERROR 1 (E1):
When power on treadmill and press START key,
the computer cannot read speed signal from motor in 7 seconds:
●
ERROR 6 (E6): When drive the incline motor and, the computer
cannot read VR value from incline motor in 6 seconds:
COMPUTER OPERATING
21