Assembly Instructions
Page 8
Hardware Required
A s s e m b l y S t e p 4
BRU178/10
8
Monitor Assembly
Remove the
Screws (#34)
that are pre-assembled on the
Monitor
(#30)
and set them aside for now.
Connect the
Monitor Wire (Middle) (#33)
to the
Monitor Wire
(Upper) (#36)
. Next, connect the
Hand Pulse Sensors (#28)
each to one
Hand Pulse Wire (#35)
. Tuck in the connected wires
into the hole on the
Front Post (#05)
to avoid pinching the wires.
Next, secure the
Monitor (#30)
to the
Front Post (#05)
using the
previously removed
Screws (#34)
.
Handlebar Assembly
Remove the
Bolts (#08)
and
Arc Washers (#10)
that are pre-
assembled on the
Front Post (#05)
and set them aside for now.
Attach the
Handlebar (#06)
to the
Front Post (#05)
as shown
in the diagram below and secure using the previously removed
two
Bolts (#08)
and two
Arc Washers (#10)
.
The assembly process is now complete.
However
, for your own safety,
please make sure to read this entire Owner’s Manual which includes
safety instructions and warnings, as well as any safety/warning labels
affixed to the product before use.
For your safety, please visually and functionally inspect and test the unit
after assembly is complete.
After complete assembly: If the computer
is
not picking up your hand pulse signal
(or you are getting inaccurate readings),
Please refer to our “Troubleshooting”
section on
Page 12
for other troubleshoot
issues.
HAND PULSE SIGNAL
Troubleshooting
#08. Bolt (M8x15 mm)
[2 Pieces]
#34. Screw (M5x10 mm)
[2 Pieces]
#10. Arc Washer (M8)
[2 Pieces]
Feed the wires of the
Hand Pulse Sensors(#28)
through the neck
of the
Front Post (#05)
until they are exposed and
accessible from the opening
as illustrated.
28
05
