Page 5
Assembly Instructions
A s s e m b l y S t e p 1
Hardware Required
BRU178/10
8
A.) Front & Rear Stabilizer Assembly
Remove the
Bolts (#08)
and
Arc Washers (#09)
that are pre-
assembled on the
Front Stabilizer (#02)
and set them aside
for now. With the help of an assistant, insert the tip of the
Front Stabilizer (#02)
up into the lower protruding base
tube on the
Main Frame (#01)
. Please refer to illustration
below for reference. Secure using the previously removed
four
Bolts (#08)
and four
Arc Washers (#09)
.
Attach the
Rear Stabilizer (#03)
to the back of the
Main
Frame (#01)
as illustrated and insert two
Carriage Bolts
(#14).
Then, secure with two
Arc Washers (#13)
followed
by two
Cap Nuts (#12)
.
B.) Pedal Assembly
Please pay special attention to the turning direction of pedals to avoid
damaging/stripping pedal parts
.
Screw the
Left Pedal (#16)
to the left pedal crank located
on the
Main Frame (#01)
by turning the bolt head on the
Left Pedal (#16)
counter-clockwise.
Screw the
Right Pedal (#15)
to the right pedal crank
by turning the bolt head on the
Right Pedal (#15)
clockwise.
Make sure these two wires are accessible and exposed (as shown) before
proceeding to the next step. If they have fallen inside the tube, use a
bent wire to “fish” them out.
#08. Bolt (M8x15 mm)
[4 Pieces]
#09. Arc W
asher (M8,φ20)
[4 Pieces]
#12. Cap Nut (M10)
[2 Pieces]
#13. Arc Washer (M10)
[2 Pieces]
#14. Carriage Bolt (M10x57 mm)
[2 Pieces]
NOTE:
If labels designating the Left/Right Pedal are not
present, please check pedals closely for embossed
“L”/ “R” letter marks. These will be “L” / “R” letters
that are raised on the pedal material.
