Assembly Instructions
Hardware Required
A s s e m b l y S t e p 2
W A R N I N G
Do not remove the
Seat (#21)
for any
reason after you have installed it.
Exercising on this unit without the
Seat
(#21)
can result in SERIOUS INJURY.
Ensure the seat is locked in place by
tightening the two knobs prior to use.
BRU178/10
8
Seat Post Assembly
First, remove the pre-assembled
Nylon Nuts (#19)
and
Washers
(#20)
from the
Seat (#21)
and set them aside for now.
Next, attach the
Seat Post (#04)
to the bottom of the
Seat (#21)
as shown in the illustration below using the previously removed
three
Nylon Nuts (#19)
and three
Washers (#20)
. Please ensure
that the holes on the bottom of the
Seat Post (#04)
face the back
of the
Seat (#21)
for proper assembly.
Now, insert the
Seat Post (#04)
with
Seat (#21)
attached into
the protruding tube of the
Main Frame (#01)
down a minimum
of 4 inches to engage the lowest hole setting for now. You can
adjust the
Seat Post/Seat (#04/#21)
for comfort and height later,
after complete assembly of the unit.
Insert the
Knob (#22)
through the hole on the
Main Frame (#01)
and through the
Seat Post (#04)
, making sure to engage
corresponding holes.
Page 6
#20. Washer (M8)
[3 Pieces]
#19. Nylon Nut (M8)
[3 Pieces]
#22. Knob (M10x60mm)
[1 Piece]
