Hardware Required
Page 7
TENSION WIRE ASSEMBLY
Insert the tip of the
Tension Controller
(25)
wire into the
Tension Controller
Wire (32)
head at an angle. Tilt the
Tension controller (25)
wire into the
crevice and then pull upward.
Make sure this wire is exposed and
accessible before assembling the
Front Post (#05).
Assembly Instructions
55
40
1
2
3
4
55
40
1
2
3
4
STEP3:
A s s e m b l y S t e p 3
BRU178/10
8
Tension Controller Assembly
Please remove the pre-assembled
Screw (#23)
and
Arc Washer
(#24)
from the
Tension Controller (#25)
and set them aside for
now. Next, insert the
Tension Controller (#25)
into the slot on the
Front Post (#05)
as seen in illustration and secure using
the previously removed
Screw (#23)
and
Arc Washer (#24)
.
Please make sure to tuck the wire of the
Tension Controller (#25)
down through the
Front Post (#05)
and be careful not to pinch
the wire during assembly.
Wire Connection
Please remove the
Bolts (#08)
and
Arc Washers (#09)
pre-
assembled on the front protruding post of the
Main Frame (#01)
and set them aside for now. With the help of an assistant, connect
the
Monitor Wire (Middle) (#33)
to the
Monitor Wire (Lower) (#31)
.
Next, connect the
Tension Controller Wire (#32)
to the wire of the
Tension Controller (#25)
at the bottom of the
Front Post (#05).
Front Post Assembly
With the help of an assistant, insert the
Front Post (#05)
over the
front protruding post of the
Main Frame (#01)
and secure using
the previously removed four
Bolts (#08)
and four
Arc Washers
(#09)
.
#23. Screw (M5x45 mm)
[1 Piece]
#24. Arc Washer (M5)
[1 Piece]
#08. Bolt (M8x15 mm)
[4 Pieces]
#09. Arc W
asher (M8,φ20)
[4 Pieces]
