Assembly Instructions
BRM 3600 Stride Cycle
Page 9
#42 WASHER FOR M10 BOLT,T2.0 1PC
S13
#42 WASHER FOR M10 BOLT,T2.0 1PC
A s s e m b l y S t e p 6
Hardware Required
Tool Required
#42 WASHER FOR M10 BOLT,T2.0 1PC
#42 WASHER FOR M10 BOLT,T2.0 1PC
Spring Loaded Knob Operation
Turn knob counter-clockwise three times.
Pull knob outward and adjust seat simultane-
ously
Push knob back inward until it clicks and then
tighten it by turning clockwise.
W A R N I N G
Do not remove the
Seat (#33)
for any
reason after you have installed it.
Exercising on this unit without the
Seat
(#33)
can result in SERIOUS INJURY.
Ensure the seat is locked in place by
tightening the two knobs prior to use.
#42. Washer
[1 pieces]
#43. Knob (M10)
[1 piece]
#39. Spring Loaded Knob
[1 piece]
71
72
#72. Nylon
N
ut
[
3
pieces]
#71. Washer
[
3
pieces]
Seat Assembly
Remove the Washers and Nuts that are pre-assembled on the
back of the
Seat (#33
) and set them aside as they will be used
in later in this process. Attach the
Seat (#33)
onto the
Horizontal
Seat Bar (#35),
ensuring that it is pointing directly toward the
short end of it and then
tighten with three
Washers (#71)
and three
Nylon Nuts (#72)
that were previously removed.
Horizontal Seat Bar (#35)
onto the
Seat Post (#36)
by inserting the bolt (on the bottom of the
Horizontal Seat Bar
(#35
)) through the
Seat Post (#36)
, secure them using a
adjust the distance of the seat from the
The
Spring Loaded Knob (#39)
has a safety
feature that allows you to loosen it by turning it
counter-clockwise three times as you pull outward.
Adjust the seat height and then pop the knob back
in. Tighten the knob by turning clockwise. Please
Washer (#42)
and a
Knob (#43)
. This knob can be loosened to
handle bars. Make
sure to tighten the knob after making any adjustment.
Attach the
refer to illustration below.
Insert the
Seat Post (#36)
into the mouth of the post that is protruding
from the
Main Frame (#48)
down a minimum of 4 inches to engage
the lowest hole. Please ensure that the hole on the
Seat Post (#36)
is
facing the same side as the
Spring
Loaded Knob (#39)
so it can be
aligned and fully engage through the lowest corresponding hold on the
Main Frame (#48)
. Screw in the
Spring
Loaded Knob (#39)
through
the
Main Frame (#48)
post and fully through (at minimum) the
lowest hole located on the
Seat Post (#36)
. Please refer to illustration.
You may adjust the
Seat Post (#36)
to the height most comfortable for
you after complete assembly. Please always check to ensure a hole
has been fully engaged when you secure and tighten the
Spring
Loaded Knob (#39)
.
