Assembly Instructions
PEDAL ASSEMBLY
Attach the two
Pedals (#13)
as shown using a
total of four
Bolts (#12)
, four
Washers (#71)
and four
Nylon Nuts (#72)
. The pedals are
marked with "L" or "R". Make sure the pedals
are positioned as shown otherwise they
will not fit properl
y
. If the pedals do not fit,
make sure that you installed the
Spacer (#31)
correctly during step number 3.
A s s e m b l y S t e p 7
Hardware / Tool Required
Hardware / Tool Required
A s s e m b l y S t e p 8
COMPUTER ASSEMBLY
Connect the
Main Sensor Wire [upper] (#52)
to
the corresponding
Main Sensor Wire [middle]
(#54)
. Then connect the
Pulse Sensor Wires
[upper] (#53)
to the other two
Pulse Sensor
Wires [lower] (#64)
. It does not matter which
Pulse Sensor Wire [upper] (#53)
you connect
to the
Pulse Sensor Wire [lower] (#64)
because
they are both identical. Attach the
Computer
(#51)
to the bracket on the
Center Post (#58)
by
using two
Screws (#63)
.
#12. Bolt (M8x45 mm)
[4 pieces]
#71. Washer
[4 pieces]
#72. Nylon Nut
[4 pieces]
#63. Screw (M4 x 10mm)
[2 pieces]
After complete assembly: If the computer
is
not picking up your hand pulse signal
(or you are getting inaccurate readings),
Please refer to our “Troubleshooting”
section on
Page 12
for other troubleshoot
issues.
HAND PULSE SIGNAL
Troubleshooting
BRM 3600 Stride Cycle
Page 10
The assembly process is now complete.
However
, for your own safety,
please make sure to read this entire Owner’s Manual which includes
safety instructions and warnings, as well as any safety/warning labels
affixed to the product before use.
For your safety, please visually and functionally inspect and test the unit
after assembly is complete.
